Welcome Guest. Sign inor Signup

1 Answers

Mitsubishi L200 overheating

I would try to flush the coolant to make sure there is flow through it. Also, try to raise up your vehicle in the front to bleed the coolant system one more time. Can you see any white smoke from the ...

Answered by: Ask A Mechanic Admin 4 views

2 Answers

2005 Honda Civic 1.7 L Excessive Coolant Expansion

You can have a leak between the cylinder pressure and the coolant. It does often result in white smoke from the exhaust pipe but you will not get any oil in the coolant and vice versa. Try to bleed yo...

Answered by: Ask A Mechanic Admin 3 views

1 Answers

04 Pontiac Grand Am 3.4 V6

It depends on how much coolant you have in your oil and vice versa. If it's a low amount of coolant you could add the fluid first. If it's a lot of coolant in the oil, I would do two oil & filter repl...

Answered by: Ask A Mechanic Admin 4 views

2 Answers

Intercooler leak Kia Sorento 2.5 TDI

Thank you :)

Answered by: Slavcho Valeriev Yovkov 5 views

1 Answers

My 2005 ford 500 won’t start after I changed the alternator

It does have to be a loose connector or a damaged wire if it was the only thing you were doing. It could also be caused by an immobilizer while you were doing the job. Try to lock and unlock the car a...

Answered by: Ask A Mechanic Admin 6 views

1 Answers

2001 Ford KA 1.0 liter possible transmission issue

Hello. Go to our contact page to send us an email with the sound. Noise problems can be really hard to diagnose via internet and the best way should be to let a mechanic take a drive with your car. Bu...

Answered by: Ask A Mechanic Admin 6 views

1 Answers

Turn Signal not working but the hazards do 97 mitsubishi eclipse

If you can reach the turn signal switch and own a multimeter, you should measure if you are getting any power and ground into the switch at any of the pins. Then check if you get a voltage or ground o...

Answered by: Ask A Mechanic Admin 4 views , ,

1 Answers

Air condition goes on but no longer blows cold Toyota Sienna SE

You have to check the pressure in the AC system to solve the problem. The best way is to take it to a car repair workshop with an AC machine to check the pressure and check how much ac gas there is in...

Answered by: Ask A Mechanic Admin 4 views

2 Answers

Car won’t start Mitsubishi outlander 2008

The car had been driven then stopped. Then in the morning I tried to start it turned over and cut out. The pressure was checked and came back OK nothing is showing up on code reader apart from glow pl...

Answered by: Anderz867 8 views , , , , ,