My 2012 barina cd while driving lost acceleration power and started coughing and spluttering as well the engine and traction light coming on and off now engine light stays on flashes here and there is reluctant to stall
I have a 01 ford crown vic.
Serpentine belt snapped few days ago and the ac/clutch pulley had to be replaced as well. After these 2 parts were replaced the car is now misfiring and w ont go over 15 mph
Hi, if you drive a 2014 Insignia for 40 miles with no gear oil, could it cause damage to the gearbox, clutch and flywheel?
Also, can the mileage go out by the car being towed, or would it actually have to be driven for the mileage to go up?
Hi, I got the spark plugs replaced for my 2005 Kia Sedona minivan as regular maintenance, but immediately after that, the engine started making loud knocking noise and shuddering.
The car was regularly maintained and just had oil change and routine inspection about 1 week ago. And the NGK spark plugs definitely fits the car. Could you please give me some idea what might caused the noise? Thank you so much!
I recently had my transmission rebuilt and new clutch installed on my 96 jeep cherokee (4.0 l6 5 speed)
I am having issues now where I am having trouble shifting into 2nd gear especially when it’s cold. I can also feel slight rubbing as I shift through all gears. The mechanic that did the rebuild can no longer be reached.
Hi we having difficulties installing a subwoofer and amp into my car, and I’m wondering how we get the positive terminal cable past the glovebox, we have lodged the glovebox so it’s out of the way but can’t find where to penetrate the car to allow the cable through the car
2002 Jeep Liberty 3.7L 4×4 sport. I installed a new passenger side, front, catalytic converter. The problem is a leak at the V Band clamp where the converter and manifold meet. I reused the old band clamp. What is the proper install method and can I reuse the old clamp? Am I missing a gasket? I could tighten it down more but I’m wary of damaging the converter and the manifold. Thank you very much.
I have a 94 jeep yj leaker trans fluid from the torque converter seal I replaced it a month a go and just now is leaking a lot now it first went out when I went for a hour drive and then went out on the free way I started having problems when I went off roading and went through water on the way back home noticed it was slipping and got home i checked the fluid which it was low and little dark so I changed the fluid and filter I drove it around the neighborhood and was slipping just a little so I add bottle of Lucas trans fluid and worked really good but when I went on the hour drive the torque converter seal went out
I used an old container of washer fluid and found an oily, obscuring residue on my windshield with each use. flushed the reservoir repeatedly, added brand new fluid and got the same problem. flushed the reservoir again and added just water. same problem.
Nissan Sentra 2014
I have a 2012 2 ltr diesel Seat Leon FR 550 and it keeps going to limp mode. There are days when its completely fine but recently its becoming constant. When starting car and leaving it running for 3 mins, an orange coil type light shows up on the dashboard. Is there anything that can be done without a costly visit to a mechanic to figure out why this happens or anything i can do to prevent going forward? I am not very knowledgeable on cars so if more info needed i will provide. Thanks, Rodney.
I bought new calipers for my 2010 Dodge Charger and I understand its right rear, left rear, the front right and left when it comes to bleeding the breaks but is there a order for the calipers to be replaced? And am I suppose to do the bleed prices after all 4 calipers are replaces or every time I replace a caliper